Schematics > Microcontrollers > Ponyprog Circuit for ATMEL'S AVR
Ponyprog Circuit for ATMEL'S AVRThe ATMEL AVR programmer works with the Windows program "Ponyprog" which
works under 95, 98, XP, ... and can be found at
http://www.lancos.com/prog.html
On board the AVRs that can be programmed are those in the schematic. For
other members of AVR family or the rest programmable ICs that Ponyprog can
program, there is the J1 connector (CON10) which allows expanding the
programmer's hardware. See Ponyprog's site for other's ICs Ponyprog circuits.
The JUMP1 jumper is there to connect the crystal's circuitry to the 8-
pin AVRs or to disconnect it. Some AVRs have internal RC oscillator and an
external XTAL is not allowed or needed. Check the JUMP1's table and the
datasheet for the AVR of your choice for more details. The JUMP2 jumper is there
to allow programming a member of the AT89Sxxxx family or the AVR's AT90Sxxxx &
ATmegaxxx family.
Download above in pdf
Kyriakos Kontakos (kkontak@hotmail.com)
Title: Ponyprog Circuit for ATMEL'S AVR
Source: www.electronics-lab.com
Published on: 2005-02-02
Reads: 735
Print version:  Other schematics from Microcontrollers
EPROM adapter for ATMEL 89 Series Flash Microcontroller Programmer Ver 2.0 Programmers for Jupiter Card Servo Motor Control with PIC16F84 Gold wafer cards "SimpleMouse" Smartcardprogrammer Funcard Programmer by Diesel Phoenix Programmer Producing your own Decrypt Viewing Card Mk2 Telephone operated remote control using PIC16F84A microcontroller PIC diode tester
Schematics > Microcontrollers > Ponyprog Circuit for ATMEL'S AVR | 
Home
