Schematics > Motor, light and power control > IR Remote Control Jammer
IR Remote Control JammerDon't like your little brother's TV channel selection? Hate the volume your
wife sets the stereo at? Want to just annoy someone? This circuit does all that
and more by jamming most IR remote signals. The circuit releases a flood of
pulsing IR light that confuses the reciever by corrupting the data stream.
Schematic
Parts:
| Part |
Total Qty. |
Description |
Substitutions |
| R1 |
1 |
100K 1/4W Resistor |
|
| R2 |
1 |
150K 1/4W Resistor |
|
| R3 |
1 |
10K 1/4W Resistor |
|
| R4 |
1 |
1K 1/4W Resistor |
|
| R5 |
1 |
See "Notes" |
|
| C1 |
1 |
10nF Ceramic Disc Capacitor |
|
| C2 |
1 |
1uF Electrolytic Capacitor |
|
| D1, D2, D3 |
3 |
High Output IR LED |
|
| Q1 |
1 |
2N4403 PNP Transistor |
|
| Q2 |
1 |
2N4401 NPN Transistor |
|
| S1 |
1 |
Normally Open Momentary Push Botton |
|
| B1 |
1 |
4.5V Battery (Three "AA"'s In Series) |
|
| MISC |
1 |
Wire, Case, Board |
|
Notes:
1. Email Carl with questions,
comments, etc.
2. You may need to adjust the value of R3 for the right frequency. A pot can
be used.
3. You may only need one IR LED.
4. It goes without saying that this circuit should be used with descretion.
Title: IR Remote Control Jammer
Source: www.aaroncake.net
Published on: 2005-02-03
Reads: 428
Print version:  Other schematics from Motor, light and power control
Expandable 16 Stage LED Sequencer Super simple stepper motor controller 220 Volts Flashing Lamps Digital Stopwatch 0-60sec Infa-Red Remote Control 1.5 Hour Lamp Fader (Sunset Lamp) Triple Stroboscope Light Activated Relay Automatic 12 Volt Lamp Fader Flashing Neons (NE-2 / NE-51)
Schematics > Motor, light and power control > IR Remote Control Jammer |
Home
