Circuits & schematics

Electronics guide

Electronic circuits and electronic schematics

This was the first of the interface boards developed in conjunction with members of the Educational Computing Association of Western Australia (ECAWA). This board follows on from the "Simplified Output Interface". We wanted to be able to experiment with the input lines using a battery powered interface. Everything has been compacted to keep the board costs to a minimum.

You can use a nine volt battery for normal use. (The diode connected to the negative terminal will protect the 7805 voltage regulator against reverse polarity.) If you want to try driving stepper motors you will need to use a 12 volt supply able to deliver at least one amp. The supply should be regulated!!

If you wanted to, you could connect a small DC electric ("hobby") motor directly across an output line. As long as the total current drawn through the ULN2803 was less than one amp you should have no problems.

For sample Visual Basic Code see: http://www.southwest.com.au/~jfuller/vb/vbout.htm

For further information on interfacing, download the booklet at: http://www.southwest.com.au/~jfuller/robot3.zip

 

Component Overlay

The Simplified I/O Interface

  

PCB Artwork for the Simplified I/O Interface.
(Permission is granted for the download, duplication and non-commercial use of this image.)

Schematic of the ULN2803 Integrated Circuit showing detail for one driver line.

Parts List
8 x 3mm LEDs
8 x 390 ohm 1/4 watt resistors
4 x 100 kohm 1/4 watt resistors
1 x 10 kohm 1/4 watt resistor
1 x 1N4001 Diode
1 x 7805 voltage regulator
1 x 0.01 uF greencap capacitor
1 x ULN 2803
1 x 74LS244
1 x 15 volt zener diode
1 x PCB mount, right angled DB25 socket
1 x PCB
1 x 9 volt battery clip
1 x 25 pin male to male cable
1 x 9 volt battery
Optional: 9 x 2-way PCB Mount Screw Terminals

Title: The Simplified I/O Interface
Source: www.southwest.com.au/~jfuller
Published on: 2005-02-03
Reads: 476
Print version: